1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.
2. Peal off the top label.
3. Fill the syringe with
7 ml. of color ink.
4. Very S-L-O-W-L-Y inject ink into each chamber until the
sponge full. A little ink might come out of the top when full, so cover up the other two
holes while filling one.
5. When finished leave
the top label off and the filling holes exposed (when printing it has to
pull in air).
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following page:
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
On some of the newer Dell cartridges the filling holes are very small and
need to be drilled out larger so the syringe needle can enter the
A Refill Kit should include
Three 10cc Syringes
One Thumb Drill